Projects
2,510 builds, from a first LED to a final-year project. Every card shows the circuit you will build.
Desk climate monitor
0 to 25 V DC voltmeter with LCD
1-Wire sensor bus
12-bit voltmeter on a Blue Pill
18650 battery capacity tester
20-second hand wash timer
3-to-8 decoder selector
3.3 V and 5 V logic levels lab
360° photo turntable
3D printer control with a Pi
3D printer filament runout and jam sensor
3×3×3 LED cube
4-bit binary adder with display
4-digit clock
4–20 mA sensor reader
555 PWM motor speed controller
555 delay timer with relay
555 timer LED flasher
8-step sequencer synth
AAA battery life gauge
ADC and DAC lab on one chip
Active and passive buzzer tour
Active low-pass and high-pass filters
Address decoder lab with a 74HC138
Address decoder with eight LEDs
Addressable LED strip with light modes
Adjustable tone generator
Air quality map on a bicycle
Alarm with latch memory
Altimeter and vertical speed logger
Analog IR distance meter
Analog multiplexer data selector
Animated eight-by-eight faces
Applause meter
Aquaponics fish tank monitor
Arduino as ISP programmer shield
Atari Punk Console noise synth
Audio source switcher
Aurora ring lamp
Auto-off when the room is empty
Auto-speed DIY air purifier
Automatic fading night light
Automatic night lamp with LDR and relay
Automatic plant watering system
Automatic poultry feeder
Automatic sliding door model
BCD switch to display
BLE sensor with a custom GATT service
Common questions
What is a guided build?
A step-by-step project with the full parts list, a wiring table, tested code, a simulation where possible, tests to show it works and a troubleshooting section.
Which Arduino project should a beginner do first?
Pick a project marked Beginner, such as blinking or dimming an LED or reading a sensor. They need few parts, take under an hour and teach the wiring and code every later build uses.
What is the difference between a build and an idea?
A build has every step written and tested. An idea describes the project, how it works and the parts it needs, for you to plan yourself or turn into a final-year or mini project.
Which boards do the projects use?
Most builds use an Arduino Uno, Nano or Mega (clone boards work), or an ESP32 for Wi-Fi and IoT projects.
Where do I get the parts?
Each build lists its parts with a Buy at Geekobot link. ElectroLark itself does not sell parts.
