Fault finder
Find the fault with your multimeter
Pick the build that is not working. We tell you exactly where to put the probes, what you should see, and what a wrong reading means.
You need: any digital multimeter (a basic DT830-type meter is enough), your build, and the USB cable. New to the meter? Read the 5-minute lesson.
Not sure which build? Start from the symptom
Pick what is wrong. We ask one check at a time and stop at the first thing that fails.
Or pick your build for exact probe points
Loading…
Common questions
My Arduino project does not work. Where do I start?
Check power first: measure the supply at the board and at each module with a multimeter. Then check each connection against the wiring table, and only then the code. The fault finder walks you through these checks for each build.
What multimeter setting do I use?
DC volts (V with a straight line) for supply and pin checks, and continuity (the beep setting) with the power off for wires and joints.
