How do you build a motor thrust test stand?
A load cell measures the thrust of a brushless motor and prop while the Arduino logs throttle, current and voltage, to pick the right prop. You need Arduino Uno R3, Load cell 5 kg (bar type), HX711 load cell amplifier, Brushless motor A2212 1000 KV, 30 A brushless ESC, Drone propellers 1045 (pair), Hall effect current sensor ACS758 (50 A), Voltage sensor module (0 to 25 V) and Li-Po 3S 11.1 V 2200 mAh 30C (drone).
- Level
- Intermediate
- Time
- About 300 min
- Parts
- 9
Measure force and electrical power together and compute grams per watt.
Parts list
- Development Boards
- Sensors
- Sensors
- Motors & Actuators
- Motors & Actuators
- Motors & Actuators
- Sensors
- Sensors
- Batteries
How to build it
- Bolt the motor on a lever over the load cell
- Drive the ESC with the Servo library from 0 to 70 % in steps
- Log thrust, current and voltage at each step
- Compute grams of thrust per watt
- Keep fingers well away and use a guard
Common questions
What parts do I need for the motor thrust test stand?
Arduino Uno R3, Load cell 5 kg (bar type), HX711 load cell amplifier, Brushless motor A2212 1000 KV, 30 A brushless ESC, Drone propellers 1045 (pair), Hall effect current sensor ACS758 (50 A), Voltage sensor module (0 to 25 V) and Li-Po 3S 11.1 V 2200 mAh 30C (drone).
How long does the motor thrust test stand take to build?
About 300 minutes for a intermediate maker.
