ACS712 current sensor module (5 A / 20 A / 30 A)
Hall-effect current sensor for AC or DC that keeps the measured circuit isolated.
What is the ACS712 current sensor module (5 A / 20 A / 30 A) and what is it used for?
Hall-effect current sensor for AC or DC that keeps the measured circuit isolated. Makers use it for measuring motor and appliance current.
Load current flows through a copper path inside the chip, and a Hall sensor measures its magnetic field, keeping the measured circuit isolated.
Key specifications
| Sensor spec | Value |
|---|---|
| Measures | AC or DC current |
| Range | ±5, ±20 or ±30 A by version |
| Accuracy | About ±1.5 % at 25 °C |
| Interface | Analog voltage, 2.5 V at 0 A |
| Supply voltage | 5 V |
| Watch out for | Sensitivity 185, 100 or 66 mV per A by version |
Pinout
How to use it
Put the module in series with one wire of the load. Read OUT and subtract the 2.5 V zero point, then divide by the sensitivity (185, 100 or 66 mV per A). On a 3.3 V ADC use a divider, and measure the zero point at start-up because it drifts.
Applications
Builds that use it
Solar water pump dry-run protector
Small DC current meter
Fume extractor with interlock
Fume extractor with interlock
Remote farm pump starter with status
Motor current meter
DC ammeter for low-voltage projects
Low-voltage current sensor lab
Alternatives
- INA219 Current MonitorMore precise for small DC currents
- SCT-013 split-core current transformerClip-on AC measurement without breaking the wire
Common questions
What is the ACS712 current sensor module (5 A / 20 A / 30 A) used for?
In maker projects: measuring motor and appliance current.
How does the ACS712 current sensor module (5 A / 20 A / 30 A) work?
Load current flows through a copper path inside the chip, and a Hall sensor measures its magnetic field, keeping the measured circuit isolated.
What voltage does the ACS712 current sensor module (5 A / 20 A / 30 A) need?
5 V.
How do I connect the ACS712 current sensor module (5 A / 20 A / 30 A) to an Arduino or ESP32?
Analog voltage, 2.5 V at 0 A. Pins: VCC (5 V), OUT (Analog, 2.5 V at 0 A, rising or falling with current direction), GND (Ground), IP+ and IP− (Screw terminals in series with the load).
What can I use instead of the ACS712 current sensor module (5 A / 20 A / 30 A)?
INA219 Current Monitor and SCT-013 split-core current transformer.
