Projects / Ideas / DC ammeter for low-voltage projects

DC ammeter for low-voltage projects

IntermediateTest & MeasurementIdeaReviewed
In short

How do you build a DC ammeter for low-voltage projects?

A Hall-based current sensor shows current of a low-voltage motor or LED load on a display. You need Arduino Uno R3, ACS712 current sensor module (5 A / 20 A / 30 A), SSD1306 OLED Display, Mini submersible water pump (3 to 6 V), Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 150 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Measure DC current without a series resistor.

How to build it

  1. Calibrate the zero-current offset
  2. Read the sensor
  3. Convert to amps
  4. Show current and peak on the OLED
  5. Use only low-voltage DC loads

Related projects

Common questions

What parts do I need for the DC ammeter for low-voltage projects?

Arduino Uno R3, ACS712 current sensor module (5 A / 20 A / 30 A), SSD1306 OLED Display, Mini submersible water pump (3 to 6 V), Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the DC ammeter for low-voltage projects take to build?

About 150 minutes for a intermediate maker.