Idea
In short
How do you build a fume extractor with interlock?
A soldering or paint station only allows the tool to power up when the extractor fan is running. You need Arduino Nano, 12 V DC fan 80 mm, ACS712 current sensor module (5 A / 20 A / 30 A), Relay Module 5V, 12 V 2 A DC adapter, LED 5 mm red, LED 5 mm green and Resistor 220 Ω × 2.
- Level
- Beginner
- Time
- About 90 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Interlock one device on another.
Parts list
- Development Boards
- Motors & Actuators
- Sensors
- Interfaces
- Power
- Semiconductors
- Semiconductors
- PassivesResistor 220 Ω × 2
How to build it
- Run the fan
- Sense fan current
- Allow the tool relay only when it flows
- Show status lights
- Keep running the fan for a minute after
Common questions
What parts do I need for the fume extractor with interlock?
Arduino Nano, 12 V DC fan 80 mm, ACS712 current sensor module (5 A / 20 A / 30 A), Relay Module 5V, 12 V 2 A DC adapter, LED 5 mm red, LED 5 mm green and Resistor 220 Ω × 2.
How long does the fume extractor with interlock take to build?
About 90 minutes for a beginner maker.
