Idea
In short
How do you build a remote farm pump starter with status?
A phone app starts and stops a borewell pump through a contactor, and shows whether three-phase power is present and the pump is really running. You need ESP32 DevKit V1, Relay Module 5V, Optocoupler isolation module (4-channel PC817), ACS712 current sensor module (5 A / 20 A / 30 A) and Waterproof enclosure IP65 (junction box).
- Level
- Advanced
- Time
- About 300 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Interface low-voltage control with a contactor and sense mains presence safely.
Parts list
- Development Boards
- Interfaces
- Interfaces
- Sensors
- Mechanical & Hardware
How to build it
- A qualified electrician wires the relay to the contactor coil in parallel with the existing starter
- Sense each phase through optocoupler modules made for mains
- Measure motor current to confirm it runs
- Show power, pump state and run time on a web page
- Never work on a live panel yourself
Common questions
What parts do I need for the remote farm pump starter with status?
ESP32 DevKit V1, Relay Module 5V, Optocoupler isolation module (4-channel PC817), ACS712 current sensor module (5 A / 20 A / 30 A) and Waterproof enclosure IP65 (junction box).
How long does the remote farm pump starter with status take to build?
About 300 minutes for a advanced maker.
