Components / Sensors / INA219 Current Monitor

INA219 Current Monitor

Measures bus current/shunt voltage and reports results digitally.

MeasuresBus voltage, shunt current and power
Range0 to 26 V bus; ±3.2 A with the usual 0.1 Ω shunt
Accuracy12-bit; about ±1 % with calibration
InterfaceI2C
SensorsReviewedMPN INA219Used in 36 projects
INA219
In short

What is the INA219 Current Monitor and what is it used for?

Measures bus current/shunt voltage and reports results digitally. Makers use it to measure a low-voltage load.

In the real world

Power instrumentation

How it works

Sensors convert a physical quantity into an electrical signal. Calibrate, verify module supply, interfaces and environmental limits.

Key specifications

Sensor specValue
MeasuresBus voltage, shunt current and power
Range0 to 26 V bus; ±3.2 A with the usual 0.1 Ω shunt
Accuracy12-bit; about ±1 % with calibration
InterfaceI2C
I2C address0x40 default (0x40 to 0x4F with A0/A1)
Supply voltage3 to 5.5 V
Operating temperature−40 to 125 °C

Pinout

VCC / GNDLogic supply
SDA / SCLI2C
VIN+From your supply
VIN−To your load

How to use it

Put it in series with the load's positive wire: supply to VIN+, VIN− to the load. Grounds must be shared. Great for measuring how long a battery will last.

#include <Adafruit_INA219.h>
Adafruit_INA219 ina;
void setup() { Serial.begin(115200); ina.begin(); }
void loop() { Serial.print(ina.getBusVoltage_V()); Serial.print(" V  "); Serial.print(ina.getCurrent_mA()); Serial.println(" mA"); delay(500); }

Applications

Buy at

Common questions

What is the INA219 Current Monitor used for?

In products: power instrumentation. In maker projects: measure a low-voltage load.

How does the INA219 Current Monitor work?

Sensors convert a physical quantity into an electrical signal. Calibrate, verify module supply, interfaces and environmental limits.

What voltage does the INA219 Current Monitor need?

3 to 5.5 V.

How do I connect the INA219 Current Monitor to an Arduino or ESP32?

I2C. Pins: VCC / GND (Logic supply), SDA / SCL (I2C), VIN+ (From your supply), VIN− (To your load).