Idea
In short
How do you build a fire-fighting robot?
Three flame sensors guide a robot towards a candle and a small pump sprays water to put it out. You need Arduino Uno R3, Flame sensor module (IR) × 3, L298N Dual H-Bridge Module, Mini submersible water pump (3 to 6 V), Relay Module 5V, SG90 Micro Servo, Robot car chassis kit 2WD (acrylic), Battery holder 18650 2S (series) and 18650 cell 2600 mAh (branded) × 2.
- Level
- Intermediate
- Time
- About 180 min
- Parts
- 9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Steer towards a target with several directional sensors and run an actuator.
Parts list
- Development Boards
- Sensors
- Motor Drivers
- Motors & Actuators
- Interfaces
- Motors & Actuators
- Mechanical & Hardware
- Power
- Batteries
How to build it
- Mount flame sensors facing left, centre and right
- Turn towards the sensor that sees the flame
- Stop 20 cm away
- Sweep the nozzle with the servo while pumping
- Test with a candle on a metal tray with an adult present
Common questions
What parts do I need for the fire-fighting robot?
Arduino Uno R3, Flame sensor module (IR) × 3, L298N Dual H-Bridge Module, Mini submersible water pump (3 to 6 V), Relay Module 5V, SG90 Micro Servo, Robot car chassis kit 2WD (acrylic), Battery holder 18650 2S (series) and 18650 cell 2600 mAh (branded) × 2.
How long does the fire-fighting robot take to build?
About 180 minutes for a intermediate maker.
