Relay Module 5V

Electromechanical switched contact module requiring appropriate drive and isolation considerations.

FunctionElectromechanical relay on a driver board
Supply voltage5 V coil, about 70 to 90 mA
InterfaceIN pin (many boards are active LOW)
RatingContacts 10 A 250 V AC / 10 A 30 V DC printed; derate for motors and LEDs
InterfacesReviewedMPN 1-channel 5 V relay moduleUsed in 63 projects
ON
In short

What is the Relay Module 5V and what is it used for?

Electromechanical switched contact module requiring appropriate drive and isolation considerations. Makers use it for study relay terminals without mains power.

The contact rating on the relay is not the rating of the cheap board's tracks and screw terminals.
In the real world

Switching suitable external loads

How it works

Interface modules bridge data or electrical signaling; verify individual module schematic and signal levels.

Key specifications

Interface module specValue
FunctionElectromechanical relay on a driver board
Supply voltage5 V coil, about 70 to 90 mA
InterfaceIN pin (many boards are active LOW)
RatingContacts 10 A 250 V AC / 10 A 30 V DC printed; derate for motors and LEDs
Logic level5 V; some boards switch from 3.3 V, many do not reliably

Pinout

VCC / GND5 V coil supply
INControl input
COMCommon contact
NONormally open: connected when on
NCNormally closed: connected when off

How to use it

Use it to switch low-voltage loads like 12 V pumps and lamps. Mains wiring needs an enclosure, fuses and a qualified person: keep learning projects at 12 V or below.

void setup() { pinMode(7, OUTPUT); digitalWrite(7, HIGH); }  // HIGH = off on active-LOW boards
void loop() { digitalWrite(7, LOW); delay(2000); digitalWrite(7, HIGH); delay(2000); }

Applications

Alternatives

Buy at

Common questions

What is the Relay Module 5V used for?

In products: switching suitable external loads. In maker projects: study relay terminals without mains power.

How does the Relay Module 5V work?

Interface modules bridge data or electrical signaling; verify individual module schematic and signal levels.

What voltage does the Relay Module 5V need?

5 V coil, about 70 to 90 mA.

How do I connect the Relay Module 5V to an Arduino or ESP32?

IN pin (many boards are active LOW). Pins: VCC / GND (5 V coil supply), IN (Control input), COM (Common contact), NO (Normally open: connected when on), NC (Normally closed: connected when off).

What can I use instead of the Relay Module 5V?

MOSFET IRLZ44N.