ESP32 DevKit V1
ESP32-based prototyping board with wireless features depending on variant.
What is the ESP32 DevKit V1 and what is it used for?
ESP32-based prototyping board with wireless features depending on variant. Makers use it to build Wi-Fi sensor logger.
Connected monitoring and device control
Development boards expose computing and I/O for prototyping. Exact board revision and power circuitry determine safe external connections.
Key specifications
| Development board spec | Value |
|---|---|
| Microcontroller | ESP32 (dual-core Xtensa LX6) on an ESP32-WROOM-32 module |
| Clock | Up to 240 MHz |
| Flash | 4 MB (module) |
| RAM | 520 KB SRAM |
| Logic level | 3.3 V, not 5 V tolerant |
| Input voltage | 5 V via USB or VIN pin (onboard 3.3 V regulator) |
| I/O pins | About 30 usable GPIO; GPIO34 to 39 are input only |
| ADC | 12-bit, up to 18 channels (ADC2 unavailable while Wi-Fi is on) |
| Wireless | Wi-Fi 802.11 b/g/n 2.4 GHz, Bluetooth 4.2 and BLE |
| Current per I/O pin | Keep under about 20 mA per pin |
Pinout
How to use it
Power it from USB while you develop. Use GPIO21 and GPIO22 for I2C. Avoid GPIO0, 2, 12 and 15 for parts that pull the line at boot, and never connect 5 V signals to a GPIO.
void setup() {
Serial.begin(115200);
pinMode(2, OUTPUT);
}
void loop() {
digitalWrite(2, HIGH); delay(500);
digitalWrite(2, LOW); delay(500);
Serial.println("alive");
}Applications
Builds that use it
Desk climate monitor
Plant soil moisture logger
ESP32 web dashboard
Sensor to phone over MQTT
Humidity display with OLED
Four sensors on one I²C bus
Light level dashboard
Door open notifier
Alternatives
- ESP32-S3 DevKitC-1Newer ESP32-S3 with native USB and more RAM; different pin numbers
- Raspberry Pi Pico WRP2040 with Wi-Fi; programmed in MicroPython or C/C++
Common questions
What is the ESP32 DevKit V1 used for?
In products: connected monitoring and device control. In maker projects: build Wi-Fi sensor logger.
How does the ESP32 DevKit V1 work?
Development boards expose computing and I/O for prototyping. Exact board revision and power circuitry determine safe external connections.
What can I use instead of the ESP32 DevKit V1?
ESP32-S3 DevKitC-1 and Raspberry Pi Pico W.
