Projects / Ideas / Greenhouse climate controller

Greenhouse climate controller

AdvancedAgricultureIdeaReviewed
In short

How do you build a greenhouse climate controller?

An ESP32 keeps a polyhouse within set temperature and humidity using an exhaust fan, a fogger pump and shade servos, with a web page to change settings. You need ESP32 DevKit V1, SHT31 temperature and humidity sensor, BH1750 light sensor, Relay module 4-channel 5 V, 12 V DC fan 80 mm, 12 V DC water pump (diaphragm), MG996R metal gear servo × 2, 12 V 2 A DC adapter, LM2596 Buck Module and Waterproof enclosure IP65 (junction box).

Level
Advanced
Time
About 360 min
Parts
10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Coordinate several actuators with hysteresis and safe limits, and expose settings over Wi-Fi.

How to build it

  1. Read temperature, humidity and light every 30 s
  2. Fan on above the high temperature, off 2 °C lower
  3. Fogger on below the humidity target, with a 2-minute maximum run
  4. Close the shade net with servos above a light limit
  5. Serve a settings page and save values in flash

Related projects

Common questions

What parts do I need for the greenhouse climate controller?

ESP32 DevKit V1, SHT31 temperature and humidity sensor, BH1750 light sensor, Relay module 4-channel 5 V, 12 V DC fan 80 mm, 12 V DC water pump (diaphragm), MG996R metal gear servo × 2, 12 V 2 A DC adapter, LM2596 Buck Module and Waterproof enclosure IP65 (junction box).

How long does the greenhouse climate controller take to build?

About 360 minutes for a advanced maker.