Projects / Ideas / Livestock GPS collar with LoRa

Livestock GPS collar with LoRa

AdvancedAgricultureIdeaReviewed
In short

How do you build a livestock GPS collar with LoRa?

A collar with GPS and LoRa reports where a grazing cow is every 15 minutes, and warns when it leaves the grazing area. You need ESP32 DevKit V1, ATGM336H GPS module, RFM95W LoRa module (868 MHz), 868 MHz LoRa antenna, Li-Po battery 3.7 V 2000 mAh, TP4056 module with protection (USB-C) and Waterproof enclosure IP65 (junction box).

Level
Advanced
Time
About 360 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Run a GPS tracker on a battery with a duty cycle and a geofence check.

How to build it

  1. Power the GPS through a MOSFET so it is off between fixes
  2. Get a fix, then sleep for 15 minutes
  3. Send latitude, longitude and battery over LoRa
  4. At the receiver, check the point against a polygon
  5. Make the collar tough and test the battery life

Related projects

Common questions

What parts do I need for the livestock GPS collar with LoRa?

ESP32 DevKit V1, ATGM336H GPS module, RFM95W LoRa module (868 MHz), 868 MHz LoRa antenna, Li-Po battery 3.7 V 2000 mAh, TP4056 module with protection (USB-C) and Waterproof enclosure IP65 (junction box).

How long does the livestock GPS collar with LoRa take to build?

About 360 minutes for a advanced maker.