Idea
In short
How do you build a bare ESP-12F Wi-Fi board?
Wire an ESP-12F module with its pull resistors and a 3.3 V regulator on a breadboard, flash it through a USB-to-serial adapter and blink an LED over Wi-Fi commands. You need ESP-12F module, USB to TTL adapter (CH340G), LM1117 3.3 V regulator, Resistor 10 kΩ × 3, Tactile push button 6 mm × 2, LED 5 mm red, Resistor 330 Ω, Electrolytic capacitor 10 µF, Ceramic Capacitor 100 nF and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 210 min
- Parts
- 10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Power and flash a bare ESP module.
Parts list
- Wireless
- Interfaces
- Power
- PassivesResistor 10 kΩ × 3
- Switches
- Semiconductors
- Passives
- Passives
- Passives
- Prototyping
How to build it
- Build the 3.3 V supply
- Wire EN, GPIO0 and GPIO15 pull resistors
- Add the reset and boot buttons
- Flash a blink sketch
- Add a simple web page to switch the LED
Common questions
What parts do I need for the bare ESP-12F Wi-Fi board?
ESP-12F module, USB to TTL adapter (CH340G), LM1117 3.3 V regulator, Resistor 10 kΩ × 3, Tactile push button 6 mm × 2, LED 5 mm red, Resistor 330 Ω, Electrolytic capacitor 10 µF, Ceramic Capacitor 100 nF and Breadboard 830 Tie Points.
How long does the bare ESP-12F Wi-Fi board take to build?
About 210 minutes for a intermediate maker.
