USB to TTL adapter (CH340G)
Low-cost USB-UART adapter with a 3.3/5 V jumper.
FunctionUSB to UART
Supply voltageUSB 5 V
InterfaceTX, RX, DTR
Logic level3.3 or 5 V by jumper
InterfacesReviewedMPN CH340G moduleUsed in 6 projects
In short
What is the USB to TTL adapter (CH340G) and what is it used for?
Low-cost USB-UART adapter with a 3.3/5 V jumper. Makers use it for programming and debugging.
How it works
A CH340G USB-to-serial chip with a crystal.
Key specifications
| Interface module spec | Value |
|---|---|
| Function | USB to UART |
| Supply voltage | USB 5 V |
| Interface | TX, RX, DTR |
| Logic level | 3.3 or 5 V by jumper |
Pinout
VCCJumper for 3.3 V or 5 V
TXD RXDSerial
DTRAuto-reset
GNDGround
How to use it
Set the jumper to match the target's logic level. Install the WCH CH340 driver if needed.
Applications
Programming and debugging
Builds that use it
Alternatives
- USB to TTL serial adapter (CP2102)3.3 V CP2102
Common questions
What is the USB to TTL adapter (CH340G) used for?
In maker projects: programming and debugging.
How does the USB to TTL adapter (CH340G) work?
A CH340G USB-to-serial chip with a crystal.
What voltage does the USB to TTL adapter (CH340G) need?
USB 5 V.
How do I connect the USB to TTL adapter (CH340G) to an Arduino or ESP32?
TX, RX, DTR. Pins: VCC (Jumper for 3.3 V or 5 V), TXD RXD (Serial), DTR (Auto-reset), GND (Ground).
What can I use instead of the USB to TTL adapter (CH340G)?
USB to TTL serial adapter (CP2102).
