How do you build an e-bike hub motor controller study?
Run a hub motor from a ready-made BLDC controller and add a throttle, brake cut-off and speed limit with an Arduino. You need Hub motor 250 W (e-bike), BLDC motor controller 24/36 V, Arduino Nano, A1302 linear hall sensor, Limit switch (micro switch with lever), Li-ion 18650 pack 3S 2P (11.1 V) and Blade fuse with inline holder (car type).
- Level
- Advanced
- Time
- About 600 min
- Parts
- 7
Understand brushless motor control and safety cut-offs.
Parts list
- Motors & Actuators
- Motors & Actuators
- Development Boards
- SensorsThrottle
- Switches
- BatteriesUse a proper 36 V pack with BMS
- Passives
How to build it
- Wire the motor phases and hall sensors to the controller
- Read the throttle and brake switch
- Cut throttle when braking
- Limit speed to 25 km/h
- Test with the wheel off the ground first
Common questions
What parts do I need for the e-bike hub motor controller study?
Hub motor 250 W (e-bike), BLDC motor controller 24/36 V, Arduino Nano, A1302 linear hall sensor, Limit switch (micro switch with lever), Li-ion 18650 pack 3S 2P (11.1 V) and Blade fuse with inline holder (car type). A1302 linear hall sensor: Throttle. Li-ion 18650 pack 3S 2P (11.1 V): Use a proper 36 V pack with BMS.
How long does the e-bike hub motor controller study take to build?
About 600 minutes for a advanced maker.
