Idea
In short
How do you build a bike that starts only with the helmet on?
A switch in the helmet sends a 433 MHz signal; the bike's ignition relay works only while the helmet is worn and the rider is sober (MQ-3 check). You need Arduino Nano × 2, 433 MHz RF transmitter and receiver pair, Limit switch (micro switch with lever), MQ-3 alcohol sensor module, Relay 30 A 12 V (automotive), LM2596 Buck Module and Li-Po battery 3.7 V 500 mAh.
- Level
- Advanced
- Time
- About 300 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Pair a transmitter and receiver and use them as a safety interlock.
Parts list
- Development BoardsArduino Nano × 2
- Wireless
- Switches
- Sensors
- Switches
- Power
- Batteries
How to build it
- Fit a micro switch inside the helmet padding
- Send a coded signal every second while it is pressed
- On the bike, allow the ignition relay only while signals arrive
- Check the MQ-3 at start
- It is a demonstration: never modify a vehicle used on the road without approval
Common questions
What parts do I need for the bike that starts only with the helmet on?
Arduino Nano × 2, 433 MHz RF transmitter and receiver pair, Limit switch (micro switch with lever), MQ-3 alcohol sensor module, Relay 30 A 12 V (automotive), LM2596 Buck Module and Li-Po battery 3.7 V 500 mAh.
How long does the bike that starts only with the helmet on take to build?
About 300 minutes for a advanced maker.
