Idea
In short
How do you build an alcohol ignition lock model?
An MQ-3 sensor checks the driver's breath before a relay allows a model car or motor to start. You need Arduino Nano, MQ-3 alcohol sensor module, Relay Module 5V, 16x2 LCD with I2C backpack (PCF8574), Active buzzer 5 V and Tactile push button 6 mm.
- Level
- Intermediate
- Time
- About 120 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Use a gas sensor as an interlock.
Parts list
- Development Boards
- Sensors
- Interfaces
- Displays
- Motors & Actuators
- Switches
How to build it
- Warm up the MQ-3 for a few minutes
- Ask the driver to blow
- Compare with a threshold
- Allow the relay only below it
- Log tests with time
Common questions
What parts do I need for the alcohol ignition lock model?
Arduino Nano, MQ-3 alcohol sensor module, Relay Module 5V, 16x2 LCD with I2C backpack (PCF8574), Active buzzer 5 V and Tactile push button 6 mm.
How long does the alcohol ignition lock model take to build?
About 120 minutes for a intermediate maker.
