Components / Sensors / MAX30102 pulse oximeter and heart rate sensor

MAX30102 pulse oximeter and heart rate sensor

Red and IR optical sensor for heart rate and a rough SpO2 reading.

MeasuresHeart rate and SpO2 (optical)
InterfaceI2C
I2C address0x57
Supply voltage1.8 V core plus 3.3 V LED (modules take 3.3 to 5 V)
SensorsReviewedMPN MAX30102Used in 7 projects
4.98V
In short

What is the MAX30102 pulse oximeter and heart rate sensor and what is it used for?

Red and IR optical sensor for heart rate and a rough SpO2 reading. Makers use it for fitness gadgets, health project demos.

How it works

Red and infrared LEDs shine into the finger and a photodiode measures how much light returns; the ratio of the two pulsing signals estimates oxygen saturation.

Key specifications

Sensor specValue
MeasuresHeart rate and SpO2 (optical)
InterfaceI2C
I2C address0x57
Supply voltage1.8 V core plus 3.3 V LED (modules take 3.3 to 5 V)
Watch out forNot a medical device; readings need still fingers

Pinout

VIN3.3 to 5 V on most modules
SCLI2C clock
SDAI2C data
INTInterrupt, active low
GNDGround
RD and IRDLED pins, leave unconnected on modules

How to use it

Use the SparkFun MAX3010x library. Hold the finger still and cover the sensor from room light. Some cheap red modules pull I2C up to 1.8 V and need a fix to work with 3.3 V boards. Not a medical device.

Applications

Alternatives

Buy at

Common questions

What is the MAX30102 pulse oximeter and heart rate sensor used for?

In maker projects: fitness gadgets, health project demos.

How does the MAX30102 pulse oximeter and heart rate sensor work?

Red and infrared LEDs shine into the finger and a photodiode measures how much light returns; the ratio of the two pulsing signals estimates oxygen saturation.

What voltage does the MAX30102 pulse oximeter and heart rate sensor need?

1.8 V core plus 3.3 V LED (modules take 3.3 to 5 V).

How do I connect the MAX30102 pulse oximeter and heart rate sensor to an Arduino or ESP32?

I2C. Pins: VIN (3.3 to 5 V on most modules), SCL (I2C clock), SDA (I2C data), INT (Interrupt, active low), GND (Ground), RD and IRD (LED pins, leave unconnected on modules).

What can I use instead of the MAX30102 pulse oximeter and heart rate sensor?

Pulse oximeter MAX30100 and Heart rate sensor (pulse sensor).