Projects / Ideas / Pulse oximeter display

Pulse oximeter display

IntermediateHealthIdeaReviewed
In short

How do you build a pulse oximeter display?

A MAX30102 sensor reads heart rate and an SpO2 estimate from a fingertip and shows them on an OLED. You need Arduino Nano, MAX30102 pulse oximeter and heart rate sensor, SSD1306 OLED Display, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 150 min
Parts
5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Process red and IR light signals to find pulse and oxygen level.

How to build it

  1. Read red and IR samples at 100 Hz
  2. Remove the slow baseline
  3. Find peaks for heart rate
  4. Estimate SpO2 from the ratio of the two signals
  5. Say clearly it is a learning project, not a medical device

Related projects

Common questions

What parts do I need for the pulse oximeter display?

Arduino Nano, MAX30102 pulse oximeter and heart rate sensor, SSD1306 OLED Display, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the pulse oximeter display take to build?

About 150 minutes for a intermediate maker.