Projects / Ideas / Wi-Fi signal strength mapper

Wi-Fi signal strength mapper

IntermediateIoTIdeaReviewed
In short

How do you build a wi-Fi signal strength mapper?

Walk around with an ESP32 and a display to log Wi-Fi signal strength and find weak spots. You need ESP32 DevKit V1, SSD1306 OLED Display, Tactile push button 6 mm, Resistor 10 kΩ, Li-Po battery 3.7 V 1000 mAh, TP4056 Charging Module, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 150 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Read RSSI and log it with notes.

How to build it

  1. Read RSSI for one network
  2. Show a bar and dBm number
  3. Save a reading on button press
  4. Log to serial with a room label
  5. Plot results in a spreadsheet

Related projects

Common questions

What parts do I need for the wi-Fi signal strength mapper?

ESP32 DevKit V1, SSD1306 OLED Display, Tactile push button 6 mm, Resistor 10 kΩ, Li-Po battery 3.7 V 1000 mAh, TP4056 Charging Module, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the wi-Fi signal strength mapper take to build?

About 150 minutes for a intermediate maker.