Projects / Ideas / Burn a bootloader with USBasp

Burn a bootloader with USBasp

IntermediateLearningIdeaReviewed
In short

How do you build a burn a bootloader with USBasp?

Use a small programmer to put a bootloader on a blank chip, then program it over serial like any board. You need USBasp AVR programmer, ATmega328P-PU (blank), Ceramic resonator 16 MHz (3-pin), Resistor 10 kΩ, Electrolytic capacitor 10 µF, Ceramic Capacitor 100 nF, LED 5 mm red, Resistor 330 Ω and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 180 min
Parts
9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Program a blank microcontroller.

How to build it

  1. Wire the chip with its clock
  2. Connect the six programming wires
  3. Burn the bootloader
  4. Upload a blink
  5. Remove the programmer

Related projects

Common questions

What parts do I need for the burn a bootloader with USBasp?

USBasp AVR programmer, ATmega328P-PU (blank), Ceramic resonator 16 MHz (3-pin), Resistor 10 kΩ, Electrolytic capacitor 10 µF, Ceramic Capacitor 100 nF, LED 5 mm red, Resistor 330 Ω and Breadboard 830 Tie Points.

How long does the burn a bootloader with USBasp take to build?

About 180 minutes for a intermediate maker.