Components / Interface and audio modules / USBasp AVR programmer

USBasp AVR programmer

Programs AVR chips and burns Arduino bootloaders.

FunctionAVR ISP programmer
Supply voltageUSB
Interface10-pin ISP (adapter to 6-pin)
Logic level5 V or 3.3 V jumper
InterfacesReviewedMPN USBaspUsed in 1 project
USBASP
In short

What is the USBasp AVR programmer and what is it used for?

Programs AVR chips and burns Arduino bootloaders. Makers use it for bootloading ATmega chips.

How it works

An ATmega8 running USBasp firmware that drives the target's SPI programming interface.

Key specifications

Interface module specValue
FunctionAVR ISP programmer
Supply voltageUSB
Interface10-pin ISP (adapter to 6-pin)
Logic level5 V or 3.3 V jumper

Pinout

10-pin ISPMOSI, RST, SCK, MISO, VCC, GND (use a 6-pin adapter for Uno ICSP)
JP13.3 V or 5 V target
JP3Slow clock for new chips

How to use it

In the Arduino IDE choose Programmer: USBasp and Burn Bootloader or Upload Using Programmer. Fit the slow-clock jumper for brand-new chips running at 1 MHz. On Windows install the driver with Zadig.

Applications

Alternatives

Buy at

Common questions

What is the USBasp AVR programmer used for?

In maker projects: bootloading ATmega chips.

How does the USBasp AVR programmer work?

An ATmega8 running USBasp firmware that drives the target's SPI programming interface.

What voltage does the USBasp AVR programmer need?

USB.

How do I connect the USBasp AVR programmer to an Arduino or ESP32?

10-pin ISP (adapter to 6-pin). Pins: 10-pin ISP (MOSI, RST, SCK, MISO, VCC, GND (use a 6-pin adapter for Uno ICSP)), JP1 (3.3 V or 5 V target), JP3 (Slow clock for new chips).

What can I use instead of the USBasp AVR programmer?

Arduino Uno R3.