Projects / Ideas / TVS diode spike clamp lab

TVS diode spike clamp lab

IntermediateSafetyIdeaReviewed
In short

How do you build a TVS diode spike clamp lab?

A transient-suppression diode clamps voltage spikes from a switched inductor. Compare with and without it on a scope. You need TVS diode P6KE6.8A, Relay Module 5V, Tactile push button 6 mm, 5 V 2 A USB adapter, Resistor 1 kΩ, USB oscilloscope / handheld scope (DSO138) and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 210 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Protect a circuit from spikes.

How to build it

  1. Switch a relay coil with no protection
  2. Capture the spike
  3. Add the TVS diode
  4. Capture again
  5. Compare the peak voltages

Related projects

Common questions

What parts do I need for the TVS diode spike clamp lab?

TVS diode P6KE6.8A, Relay Module 5V, Tactile push button 6 mm, 5 V 2 A USB adapter, Resistor 1 kΩ, USB oscilloscope / handheld scope (DSO138) and Breadboard 830 Tie Points.

How long does the TVS diode spike clamp lab take to build?

About 210 minutes for a intermediate maker.