Using an Oscilloscope: the short answer
A multimeter gives one number; an oscilloscope draws the voltage against time, so you can see PWM, serial data, ripple and noise. The screen is a grid.
- Level
- Intermediate
- Time
- About 6 min
- Topic
- Tools and measurement
Set up an oscilloscope to see a signal clearly and measure its voltage, frequency and duty cycle.
Before this: Using a Multimeter, PWM Timing & Actuator Interfaces
A multimeter gives one number; an oscilloscope draws the voltage against time, so you can see PWM, serial data, ripple and noise. The screen is a grid. The vertical scale (volts per division) sets how many volts each square represents, and the horizontal scale (time per division) sets how much time each square covers. Most scopes have 8 vertical and 10 horizontal divisions.
The trigger is what makes a repeating signal stand still. It tells the scope to start drawing each time the signal crosses a level, for example rising through 2.5 V. If the picture rolls or flickers, adjust the trigger level to the middle of the signal and pick the right channel as the source. Use Auto mode to find a signal and Normal or Single mode to capture events that happen only now and then.
Use the probe on its 10× setting for most work and set the scope channel to 10× to match, so readings are correct. Clip the probe's ground lead to the circuit's ground, close to where you measure. On a mains-powered scope, the ground clip is connected to earth: never clip it to anything connected to mains, or to a point that is not ground, because that creates a short circuit through the scope.
Set the vertical, horizontal and trigger
The vertical control sets volts per division, and the horizontal sets time per division. Start with a scale that puts the whole signal on screen, then zoom in. The trigger decides where the sweep starts: set it to a rising edge at a level in the middle of the signal, and the trace becomes stable instead of drifting.
Use normal or single trigger mode to catch an event that happens once, such as a reset glitch.
Probes and grounding
A 10× probe divides the signal by ten and presents a higher input impedance, which disturbs the circuit less; make sure the scope's channel setting matches the probe. Compensate the probe on the scope's square-wave output by adjusting the small screw until the corners are square.
A long ground lead picks up noise and rings. For fast edges or small supply ripple, remove the clip and touch the ground spring on the probe barrel directly to a ground point near the test point.
What to look for
Measure amplitude, period, rise time and ripple. Coupling set to AC removes the DC level so a small ripple on a supply can be magnified. Remember the bandwidth: a 20 MHz scope shows a 10 MHz square wave with rounded edges, because it cannot display the harmonics.
- Leaving the probe at 1× while the scope is set for 10×, reading values ten times off.
- Using a long ground lead and misreading ringing as a real fault.
- Not triggering, so the picture slides and cannot be measured.
Practise this lesson with Maker
The explanation above is free for everyone. The practice for Intermediate lessons in every domain are part of the Maker plan at ₹499 a month, and Pro includes them too.
With Maker you also get: a worked example, a hands-on task, a 3-question check.
