Idea
In short
How do you build a transistor switch comparison lab?
Switch the same LED load with a BJT, a logic-level MOSFET and a relay and compare behaviour. You need Arduino Uno R3, NPN Transistor 2N2222, MOSFET IRLZ44N, Relay Module 5V, LED 5 mm red × 3, Resistor 220 Ω × 3, Resistor 1 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Beginner
- Time
- About 180 min
- Parts
- 9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Choose a switching device for a load.
Parts list
- Development Boards
- Semiconductors
- Semiconductors
- Interfaces
- SemiconductorsLED 5 mm red × 3
- PassivesResistor 220 Ω × 3
- Passives
- Prototyping
- Prototyping
How to build it
- Wire the BJT with a base resistor
- Wire the MOSFET with a gate resistor
- Wire the relay module
- Measure the voltage drop across each
- Note the click and switching speed
Common questions
What parts do I need for the transistor switch comparison lab?
Arduino Uno R3, NPN Transistor 2N2222, MOSFET IRLZ44N, Relay Module 5V, LED 5 mm red × 3, Resistor 220 Ω × 3, Resistor 1 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the transistor switch comparison lab take to build?
About 180 minutes for a beginner maker.
