Idea
In short
How do you build a PNP transistor switch?
A PNP transistor turns an LED on when its base is pulled low, the opposite way round to an NPN. You need BD140 PNP transistor, NPN Transistor 2N2222, Resistor 1 kΩ × 2, Resistor 10 kΩ, LED 5 mm red, Resistor 220 Ω, Tactile push button 6 mm, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 150 min
- Parts
- 10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Learn the PNP switch.
Parts list
- Semiconductors
- Semiconductors
- PassivesResistor 1 kΩ × 2
- Passives
- Semiconductors
- Passives
- Switches
- Batteries
- Power
- Prototyping
How to build it
- Compare NPN and PNP
- Wire the PNP stage
- Drive it with a button
- Add a drive transistor
- Note the polarity table
Common questions
What parts do I need for the PNP transistor switch?
BD140 PNP transistor, NPN Transistor 2N2222, Resistor 1 kΩ × 2, Resistor 10 kΩ, LED 5 mm red, Resistor 220 Ω, Tactile push button 6 mm, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
How long does the PNP transistor switch take to build?
About 150 minutes for a beginner maker.
