Idea
In short
How do you build a stair-climbing tracked robot?
Flippers on a tracked chassis lift the front to climb steps, balanced by an IMU. You need Tank tracks chassis kit, MG996R metal gear servo × 2, ESP32 DevKit V1, MPU6050 IMU, L298N Dual H-Bridge Module, Li-Po 2S 7.4 V 2200 mAh 25C (RC) and LM2596 Buck Module.
- Level
- Advanced
- Time
- About 480 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Mechanisms and posture control.
Parts list
- Mechanical & Hardware
- Motors & Actuators
- Development Boards
- Sensors
- Motor Drivers
- Batteries
- Power
How to build it
- Mount servo flippers at the front
- Read pitch from the IMU
- Raise flippers when the front lifts
- Drive up in steps
- Keep the centre of mass low
Related projects
Common questions
What parts do I need for the stair-climbing tracked robot?
Tank tracks chassis kit, MG996R metal gear servo × 2, ESP32 DevKit V1, MPU6050 IMU, L298N Dual H-Bridge Module, Li-Po 2S 7.4 V 2200 mAh 25C (RC) and LM2596 Buck Module.
How long does the stair-climbing tracked robot take to build?
About 480 minutes for a advanced maker.
