Projects / Ideas / Radio-controlled boat for a pond

Radio-controlled boat for a pond

IntermediateDrones & RCIdeaReviewed
In short

How do you build a radio-controlled boat for a pond?

A foam boat with two motors and an nRF24 receiver steers by running the motors at different speeds, with a sealed electronics box. You need Arduino Nano × 2, nRF24L01+ Radio Module × 2, Electrolytic capacitor 10 µF × 2, DRV8833 dual motor driver, DC motor 130 size (toy motor) × 2, Joystick module (dual axis), Li-Po battery 3.7 V 2000 mAh, TP4056 module with protection (USB-C) and MT3608 Boost Module.

Level
Intermediate
Time
About 240 min
Parts
9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Waterproof electronics and steer with differential thrust.

How to build it

  1. Build a hull from foam board and seal it
  2. Fit two motors with small props
  3. Steer by differential speed
  4. Seal the electronics in a box with a silica gel bag
  5. Fail safe to stop the motors when the signal is lost

Related projects

Common questions

What parts do I need for the radio-controlled boat for a pond?

Arduino Nano × 2, nRF24L01+ Radio Module × 2, Electrolytic capacitor 10 µF × 2, DRV8833 dual motor driver, DC motor 130 size (toy motor) × 2, Joystick module (dual axis), Li-Po battery 3.7 V 2000 mAh, TP4056 module with protection (USB-C) and MT3608 Boost Module.

How long does the radio-controlled boat for a pond take to build?

About 240 minutes for a intermediate maker.