Projects / Ideas / Photodiode light meter with an op-amp

Photodiode light meter with an op-amp

IntermediateAnalog CircuitsIdeaReviewed
In short

How do you build a photodiode light meter with an op-amp?

An op-amp turns the tiny current of a photodiode into a voltage that follows the light, a first look at transimpedance amplifiers. You need Photodiode / IR receiver diode (5 mm black), TL071 low-noise JFET op-amp, Resistor 1 MΩ, Ceramic capacitor 100 pF, 9 V battery × 2, 9 V battery snap with DC jack × 2, Digital multimeter and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 180 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Turn light into a voltage cleanly.

How to build it

  1. Read how a photodiode makes current
  2. Wire the feedback resistor
  3. Add the small compensation capacitor
  4. Measure the output in dark and light
  5. Compare different lamps

Related projects

Common questions

What parts do I need for the photodiode light meter with an op-amp?

Photodiode / IR receiver diode (5 mm black), TL071 low-noise JFET op-amp, Resistor 1 MΩ, Ceramic capacitor 100 pF, 9 V battery × 2, 9 V battery snap with DC jack × 2, Digital multimeter and Breadboard 830 Tie Points.

How long does the photodiode light meter with an op-amp take to build?

About 180 minutes for a intermediate maker.