Projects / Ideas / Model tower crane

Model tower crane

IntermediateRoboticsIdeaReviewed
In short

How do you build a model tower crane?

A stepper swings the jib of a model tower crane left and right, a knob sets the speed, and two limit switches stop it at each end so it can never swing too far. A good lesson in limit switches and homing. Keep fingers clear of the moving jib. You need Arduino Nano, 28BYJ-48 Stepper Motor, ULN2003 driver board, 5 V 2 A USB adapter, Limit switch (micro switch with lever) × 2, Potentiometer 10 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 100 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Swing a model crane with end stops.

How to build it

  1. Wire the stepper and two limit switches
  2. Home against the left switch
  3. Swing right with the knob
  4. Stop at the right switch
  5. Report the number of steps between the ends

Related projects

Common questions

What parts do I need for the model tower crane?

Arduino Nano, 28BYJ-48 Stepper Motor, ULN2003 driver board, 5 V 2 A USB adapter, Limit switch (micro switch with lever) × 2, Potentiometer 10 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the model tower crane take to build?

About 100 minutes for a intermediate maker.