Idea
In short
How do you build a model revolving door?
A stepper turns a model revolving door one quarter-turn when a hand passes the sensor, then waits for the next. A good small project in positioning with a stepper. Keep fingers clear of the model. You need Arduino Nano, 28BYJ-48 Stepper Motor, ULN2003 driver board, IR obstacle avoidance sensor module, 5 V 2 A USB adapter, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 80 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Turn a model door a quarter turn at a time.
Parts list
- Development Boards
- Motors & Actuators
- Motor Drivers
- Sensors
- Power
- Prototyping
- Prototyping
How to build it
- Wire the stepper through its driver
- Count the steps for a quarter turn
- Trigger a turn from the sensor
- Ignore the sensor while turning
- Add a light for each door section
Related projects
Common questions
What parts do I need for the model revolving door?
Arduino Nano, 28BYJ-48 Stepper Motor, ULN2003 driver board, IR obstacle avoidance sensor module, 5 V 2 A USB adapter, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the model revolving door take to build?
About 80 minutes for a intermediate maker.
