Idea
In short
How do you build a three-joint desk arm?
Three metal-gear servos make a small arm that follows three knobs and can record and replay a motion. You need Arduino Nano, MG90S metal gear micro servo × 3, Potentiometer 10 kΩ × 3, 5 V 2 A USB adapter and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 330 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Control a small arm.
Parts list
- Development Boards
- Motors & Actuators
- Passives
- Power
- Prototyping
How to build it
- Assemble the arm
- Wire three servos on a good supply
- Map knobs to angles
- Record a short move
- Replay it
Common questions
What parts do I need for the three-joint desk arm?
Arduino Nano, MG90S metal gear micro servo × 3, Potentiometer 10 kΩ × 3, 5 V 2 A USB adapter and Breadboard 830 Tie Points.
How long does the three-joint desk arm take to build?
About 330 minutes for a intermediate maker.
