Components / Motors and drivers / ULN2003 driver board

ULN2003 driver board

Darlington array board that drives the 28BYJ-48 stepper.

Function7-channel Darlington sink driver
Supply voltage5 to 12 V motor supply
Interface4 inputs for the stepper
Rating500 mA per channel
Motor DriversReviewedMPN ULN2003Used in 16 projects
In short

What is the ULN2003 driver board and what is it used for?

Darlington array board that drives the 28BYJ-48 stepper. Makers use it for 28BYJ-48 steppers, relays.

How it works

Seven Darlington transistor pairs sink current to ground, each with a built-in flyback diode.

Key specifications

Interface module specValue
Function7-channel Darlington sink driver
Supply voltage5 to 12 V motor supply
Interface4 inputs for the stepper
Rating500 mA per channel
Logic level5 V (works from 3.3 V in most cases)

Pinout

IN1 IN2 IN3 IN4Inputs from the board
5-pin socket28BYJ-48 stepper
+ and -5 to 12 V motor supply
LEDs A to DShow each phase

How to use it

For a 28BYJ-48, use the Stepper library with pins in the order IN1, IN3, IN2, IN4, or AccelStepper in HALF4WIRE mode. A full turn of the output shaft is about 2048 full steps (4096 half steps). Power the motor from 5 V, not the board's pin.

Applications

Alternatives

Buy at

Common questions

What is the ULN2003 driver board used for?

In maker projects: 28BYJ-48 steppers, relays.

How does the ULN2003 driver board work?

Seven Darlington transistor pairs sink current to ground, each with a built-in flyback diode.

What voltage does the ULN2003 driver board need?

5 to 12 V motor supply.

How do I connect the ULN2003 driver board to an Arduino or ESP32?

4 inputs for the stepper. Pins: IN1 IN2 IN3 IN4 (Inputs from the board), 5-pin socket (28BYJ-48 stepper), + and - (5 to 12 V motor supply), LEDs A to D (Show each phase).

What can I use instead of the ULN2003 driver board?

A4988 stepper driver and 28BYJ-48 Stepper Motor.