Idea
In short
How do you build a camera slider with a stepper?
A motorised rail moves a phone slowly for smooth video, with limit switches at both ends. You need Arduino Uno R3, NEMA 17 stepper motor, DRV8825 stepper driver, 12 V 2 A DC adapter, Electrolytic Capacitor 100 µF, Tactile push button 6 mm × 2, Rotary encoder module (KY-040), Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Advanced
- Time
- About 360 min
- Parts
- 9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Control a belt drive with end stops.
Parts list
- Development Boards
- Motors & Actuators
- Motor Drivers
- Power
- Passives
- Switches
- Sensors
- Prototyping
- Prototyping
How to build it
- Build a rail and belt
- Add two limit switches
- Home at start
- Move at a set speed
- Add ease in and out
Common questions
What parts do I need for the camera slider with a stepper?
Arduino Uno R3, NEMA 17 stepper motor, DRV8825 stepper driver, 12 V 2 A DC adapter, Electrolytic Capacitor 100 µF, Tactile push button 6 mm × 2, Rotary encoder module (KY-040), Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the camera slider with a stepper take to build?
About 360 minutes for a advanced maker.
