NEMA 17 stepper motor
The standard stepper for 3D printers and CNC.
TypeBipolar hybrid stepper, 1.8° per step
Supply voltageUse a driver; rated about 1.7 A per phase
Torque or outputAbout 40 N·cm holding torque
ControlSTEP/DIR via an A4988, DRV8825 or TMC driver
Motors & ActuatorsReviewedMPN 17HS4401Used in 18 projects
In short
What is the NEMA 17 stepper motor and what is it used for?
The standard stepper for 3D printers and CNC. Makers use it for 3D printers, camera sliders.
How it works
A toothed rotor with a permanent magnet lines up with the energised coil teeth, moving 1.8° per full step.
Key specifications
| Motor or actuator spec | Value |
|---|---|
| Type | Bipolar hybrid stepper, 1.8° per step |
| Supply voltage | Use a driver; rated about 1.7 A per phase |
| Torque or output | About 40 N·cm holding torque |
| Control | STEP/DIR via an A4988, DRV8825 or TMC driver |
Pinout
A+ A-Coil A
B+ B-Coil B
Find coilsAbout 1.5 to 2 Ω between wires of one coil, open between coils
How to use it
Drive it with an A4988, DRV8825 or TMC driver, never directly from a board. Set the driver current to about 70 percent of the 1.7 A rating for a cool motor. 200 full steps per turn.
Applications
3D printerscamera sliders
Builds that use it
Guided build
Time-lapse slider
Guided build
Light-following curtains
Guided build
Pen plotter with two steppers
Guided build
Motorised camera slider for time-lapse
Guided build
Motorised curtain that opens at sunrise
Idea
CoreXY pen plotter
Idea
Rotary indexing table
Idea
Small CNC router with GRBL
Showing 8 of 18
Alternatives
- NEMA 17 pancake stepper (20 mm)Thinner, less torque
- NEMA 23 stepper motorMore torque
- A4988 stepper driverDriver
Common questions
What is the NEMA 17 stepper motor used for?
In maker projects: 3D printers, camera sliders.
How does the NEMA 17 stepper motor work?
A toothed rotor with a permanent magnet lines up with the energised coil teeth, moving 1.8° per full step.
What voltage does the NEMA 17 stepper motor need?
Use a driver; rated about 1.7 A per phase.
What can I use instead of the NEMA 17 stepper motor?
NEMA 17 pancake stepper (20 mm), NEMA 23 stepper motor and A4988 stepper driver.
