Components / Motors and drivers / DRV8825 stepper driver

DRV8825 stepper driver

Higher-current stepper driver with 1/32 microstepping.

FunctionBipolar stepper driver
Supply voltage8.2 to 45 V
InterfaceSTEP and DIR
RatingAbout 1.5 A without extra cooling, 2.2 A max
Motor DriversReviewedMPN DRV8825Used in 3 projects
In short

What is the DRV8825 stepper driver and what is it used for?

Higher-current stepper driver with 1/32 microstepping. Makers use it for quieter, stronger 3D printers.

How it works

A PWM chopper stepper driver like the A4988, with a higher voltage limit and finer microsteps.

Key specifications

Interface module specValue
FunctionBipolar stepper driver
Supply voltage8.2 to 45 V
InterfaceSTEP and DIR
RatingAbout 1.5 A without extra cooling, 2.2 A max
Logic level3.3 or 5 V

Pinout

ENLow to enable
M0 M1 M2Microstep select (up to 1/32)
RST SLPPull both high
STEP DIRStep and direction
VMOT8.2 to 45 V (100 µF capacitor)
A1 A2 B1 B2Coils
FAULTLow on over-current or over-heat

How to use it

Set current with Vref: current limit = Vref × 2, so 0.5 V gives 1 A. It fits A4988 sockets, but adjust Vref again and keep step pulses at least 2 µs long. Add a heatsink above about 1.5 A.

Applications

Alternatives

Buy at

Common questions

What is the DRV8825 stepper driver used for?

In maker projects: quieter, stronger 3D printers.

How does the DRV8825 stepper driver work?

A PWM chopper stepper driver like the A4988, with a higher voltage limit and finer microsteps.

What voltage does the DRV8825 stepper driver need?

8.2 to 45 V.

How do I connect the DRV8825 stepper driver to an Arduino or ESP32?

STEP and DIR. Pins: EN (Low to enable), M0 M1 M2 (Microstep select (up to 1/32)), RST SLP (Pull both high), STEP DIR (Step and direction), VMOT (8.2 to 45 V (100 µF capacitor)), A1 A2 B1 B2 (Coils).

What can I use instead of the DRV8825 stepper driver?

A4988 stepper driver and TMC2208 stepper driver.