Idea
In short
How do you build a light-up costume cape?
A strip of addressable LEDs on a costume runs animations powered by a small battery pack. You need Arduino Nano, WS2812B addressable RGB LED strip (1 m, 60 LEDs), Electrolytic Capacitor 100 µF, Resistor 470 Ω, 18650 Li-ion cell, Battery holder 18650 single, MT3608 Boost Module, Tactile push button 6 mm and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Power and drive an LED strip from a battery.
Parts list
- Development Boards
- Optoelectronics
- Passives
- Passives
- Power
- Power
- Power
- Switches
- Prototyping
How to build it
- Estimate strip current at a low brightness
- Boost the cell to 5 V
- Add a capacitor
- Cycle animations with a button
- Insulate all wiring
Common questions
What parts do I need for the light-up costume cape?
Arduino Nano, WS2812B addressable RGB LED strip (1 m, 60 LEDs), Electrolytic Capacitor 100 µF, Resistor 470 Ω, 18650 Li-ion cell, Battery holder 18650 single, MT3608 Boost Module, Tactile push button 6 mm and Breadboard 830 Tie Points.
How long does the light-up costume cape take to build?
About 240 minutes for a intermediate maker.
