Projects / Ideas / Heated gloves controller

Heated gloves controller

IntermediateWearablesIdeaReviewed
In short

How do you build a heated gloves controller?

Heating wire in gloves runs from a Li-ion pack with three heat levels and an overheat cut-off. You need ATtiny85-20PU microcontroller, MOSFET IRLZ44N, NTC thermistor 10 kΩ (B3950), Resistor 10 kΩ, 18650 Li-ion cell, Battery holder 18650 single, Tactile push button 6 mm and RGB LED 5 mm common cathode.

Level
Intermediate
Time
About 180 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Control heating power with PWM and a temperature sensor.

How to build it

  1. Measure the heater resistance and current
  2. Switch it with PWM at three levels
  3. Sense temperature at the fingers
  4. Cut power above 45 °C
  5. Show the level with LED colour

Related projects

Common questions

What parts do I need for the heated gloves controller?

ATtiny85-20PU microcontroller, MOSFET IRLZ44N, NTC thermistor 10 kΩ (B3950), Resistor 10 kΩ, 18650 Li-ion cell, Battery holder 18650 single, Tactile push button 6 mm and RGB LED 5 mm common cathode.

How long does the heated gloves controller take to build?

About 180 minutes for a intermediate maker.