Projects / Ideas / Egg incubator with turning and humidity

Egg incubator with turning and humidity

AdvancedAgricultureIdeaReviewed
In short

How do you build an egg incubator with turning and humidity?

A box incubator holds 37.5 °C, keeps humidity near 55 % and tilts the egg tray every two hours with a servo for 18 days, then stops turning for hatching. You need Arduino Nano, SHT31 temperature and humidity sensor, DS3231 RTC module, MOSFET IRLZ44N, Power resistor 10 Ω 5 W (cement) × 2, MG996R metal gear servo, 5 V DC fan 40 mm, 12 V 2 A DC adapter, LM2596 Buck Module, 16x2 LCD with I2C backpack (PCF8574) and Thermal fuse 72 °C.

Level
Advanced
Time
About 480 min
Parts
11
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Run a long-duration controller with a PID heater loop and a day counter that survives power cuts.

How to build it

  1. Build the box from thermocol and fit two power resistors as heaters
  2. Hold 37.5 °C with PID on the MOSFET
  3. Stir the air with the small fan
  4. Tilt the tray 45° each way every 2 hours
  5. Count days from the RTC start date and stop turning on day 18

Related projects

Common questions

What parts do I need for the egg incubator with turning and humidity?

Arduino Nano, SHT31 temperature and humidity sensor, DS3231 RTC module, MOSFET IRLZ44N, Power resistor 10 Ω 5 W (cement) × 2, MG996R metal gear servo, 5 V DC fan 40 mm, 12 V 2 A DC adapter, LM2596 Buck Module, 16x2 LCD with I2C backpack (PCF8574) and Thermal fuse 72 °C.

How long does the egg incubator with turning and humidity take to build?

About 480 minutes for a advanced maker.