Idea
In short
How do you build a mini CNC for drilling PCB holes?
Three steppers and a 12 V mini drill drill through-hole PCBs from the drill file KiCad exports. You need Arduino Uno R3, CNC shield V3 for Uno, A4988 stepper driver × 3, NEMA 17 stepper motor × 3, Lead screw T8 with nut (300 mm) × 3, Linear rod 8 mm with LM8UU bearings × 3, Mini drill (PCB, 12 V), Relay Module 5V and SMPS 12 V 5 A (metal case).
- Level
- Advanced
- Time
- About 900 min
- Parts
- 9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Convert an Excellon drill file into G-code and run it on GRBL.
Parts list
- Development Boards
- Motor Drivers
- Motor Drivers
- Motors & Actuators
- Mechanical & Hardware
- Mechanical & Hardware
- Tools & Instruments
- Interfaces
- Power
How to build it
- Build a small 3-axis frame with lead screws
- Flash GRBL and set steps per mm
- Export drill files from KiCad
- Convert to G-code with a free tool
- Zero on the board corner and drill a test board
Common questions
What parts do I need for the mini CNC for drilling PCB holes?
Arduino Uno R3, CNC shield V3 for Uno, A4988 stepper driver × 3, NEMA 17 stepper motor × 3, Lead screw T8 with nut (300 mm) × 3, Linear rod 8 mm with LM8UU bearings × 3, Mini drill (PCB, 12 V), Relay Module 5V and SMPS 12 V 5 A (metal case).
How long does the mini CNC for drilling PCB holes take to build?
About 900 minutes for a advanced maker.
