Idea
In short
How do you build an isolated supply for a serial link?
A small isolated converter gives a second ground for a serial adapter, so two boards can talk without sharing a ground wire. You need Isolated DC-DC B0505S, Arduino Nano, USB to TTL adapter (CH340G), Resistor 1 kΩ and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Isolate one side of a link.
Parts list
- Power
- Development Boards
- Interfaces
- Passives
- Prototyping
How to build it
- Read the isolation rating
- Power one side from the converter
- Link TX and RX
- Check there is no shared ground
- Measure the converter ripple
Common questions
What parts do I need for the isolated supply for a serial link?
Isolated DC-DC B0505S, Arduino Nano, USB to TTL adapter (CH340G), Resistor 1 kΩ and Breadboard 830 Tie Points.
How long does the isolated supply for a serial link take to build?
About 150 minutes for a intermediate maker.
