Projects / Ideas / Sump to tank pump controller with dry-run guard

Sump to tank pump controller with dry-run guard

AdvancedSmart HomeIdeaReviewed
In short

How do you build a sump to tank pump controller with dry-run guard?

Non-contact sensors on the sump and the overhead tank start the pump when the tank is low and stop it if the sump runs dry. You need Arduino Nano, Water level sensor (non-contact, XKC-Y25) × 3, Relay Module 5V, 16x2 LCD with I2C backpack (PCF8574), Active buzzer 5 V, 12 V 2 A DC adapter and LM2596 Buck Module.

Level
Advanced
Time
About 180 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Combine two level sensors into a pump state machine with protection.

How to build it

  1. Stick one sensor near the sump bottom and two on the tank wall (low and high)
  2. Start the pump when the tank is below low and the sump has water
  3. Stop at high or when the sump empties
  4. Beep on a dry-sump stop
  5. Show the state and today's run time

Related projects

Common questions

What parts do I need for the sump to tank pump controller with dry-run guard?

Arduino Nano, Water level sensor (non-contact, XKC-Y25) × 3, Relay Module 5V, 16x2 LCD with I2C backpack (PCF8574), Active buzzer 5 V, 12 V 2 A DC adapter and LM2596 Buck Module.

How long does the sump to tank pump controller with dry-run guard take to build?

About 180 minutes for a advanced maker.