Idea
In short
How do you build an overhead tank level gauge with pump auto-off?
An ultrasonic sensor on the overhead tank lid shows the water level on a display downstairs and switches the pump off when the tank is full. You need Arduino Nano, JSN-SR04T waterproof ultrasonic sensor, TM1637 4-digit display, Relay Module 5V, Multi-core shielded cable 4-core, 12 V 2 A DC adapter and LM2596 Buck Module.
- Level
- Intermediate
- Time
- About 180 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Measure a tank level, show it remotely over a cable and control a pump with safe limits.
Parts list
- Development Boards
- Sensors
- Displays
- Interfaces
- Cables & Wires
- Power
- Power
How to build it
- Mount the waterproof sensor in the tank lid
- Store the empty and full distances
- Show percent full on the TM1637 downstairs
- Switch the pump contactor off at 95 % and lock out until it falls to 80 %
- A qualified electrician wires the relay into the pump starter
Common questions
What parts do I need for the overhead tank level gauge with pump auto-off?
Arduino Nano, JSN-SR04T waterproof ultrasonic sensor, TM1637 4-digit display, Relay Module 5V, Multi-core shielded cable 4-core, 12 V 2 A DC adapter and LM2596 Buck Module.
How long does the overhead tank level gauge with pump auto-off take to build?
About 180 minutes for a intermediate maker.
