Projects / Ideas / DIY PWM solar charge controller

DIY PWM solar charge controller

AdvancedPowerIdeaReviewed
In short

How do you build a DIY PWM solar charge controller?

An Arduino reads panel and battery voltage and switches a MOSFET to charge a 12 V lead-acid battery with bulk and float stages. You need Arduino Nano, IRF9540N P-channel MOSFET, MOSFET IRLZ44N, 1N5822 Schottky diode (3 A), Resistor 100 kΩ × 2, Resistor 22 kΩ × 2, Solar panel 12 V 10 W, 12 V 7 Ah sealed lead acid battery, LM2596 Buck Module, Fuse 5 A glass (5 × 20 mm) and Fuse holder (panel, 5 × 20 mm).

Level
Advanced
Time
About 360 min
Parts
11
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Charge a battery in stages and protect it from overcharge and reverse current.

How to build it

  1. Measure panel and battery voltage through dividers
  2. Bulk charge with the switch fully on until 14.4 V
  3. Hold 13.6 V float with PWM
  4. Disconnect the load below 11.5 V
  5. Fuse both the panel and the battery leads

Related projects

Common questions

What parts do I need for the DIY PWM solar charge controller?

Arduino Nano, IRF9540N P-channel MOSFET, MOSFET IRLZ44N, 1N5822 Schottky diode (3 A), Resistor 100 kΩ × 2, Resistor 22 kΩ × 2, Solar panel 12 V 10 W, 12 V 7 Ah sealed lead acid battery, LM2596 Buck Module, Fuse 5 A glass (5 × 20 mm) and Fuse holder (panel, 5 × 20 mm).

How long does the DIY PWM solar charge controller take to build?

About 360 minutes for a advanced maker.