Idea
In short
How do you build a solar street light with dusk sensing?
A solar panel charges a battery by day and an LED lamp turns on at dusk for six hours, sensing light from the panel's own voltage. You need Arduino Nano, Solar panel 12 V 10 W, PWM solar charge controller 10 A, 12 V 7 Ah sealed lead acid battery, 10 W COB LED (12 V), MOSFET IRLZ44N, Resistor 10 kΩ, Resistor 100 kΩ, Resistor 22 kΩ and LM2596 Buck Module.
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Use a panel as a light sensor and manage a battery's day and night cycle.
Parts list
- Development Boards
- Power
- Power
- Batteries
- Optoelectronics
- Semiconductors
- Passives
- Passives
- Passives
- Power
How to build it
- Charge the battery through the PWM controller
- Measure panel voltage: below about 2 V means dark
- Turn on the COB LED through the MOSFET at dusk
- Turn off after 6 hours or at low battery
- Dim to 30 % after midnight
Common questions
What parts do I need for the solar street light with dusk sensing?
Arduino Nano, Solar panel 12 V 10 W, PWM solar charge controller 10 A, 12 V 7 Ah sealed lead acid battery, 10 W COB LED (12 V), MOSFET IRLZ44N, Resistor 10 kΩ, Resistor 100 kΩ, Resistor 22 kΩ and LM2596 Buck Module.
How long does the solar street light with dusk sensing take to build?
About 240 minutes for a intermediate maker.
