Idea
In short
How do you build a soldering station controller?
Control a 24 V iron's heater from its thermocouple with PID, an OLED and an encoder. You need Arduino Nano, MOSFET IRLZ44N, LM358 Op-Amp, SSD1306 OLED Display, Rotary encoder module (KY-040), Resistor 10 kΩ × 2, Resistor 1 kΩ and SMPS 12 V 5 A (metal case).
- Level
- Advanced
- Time
- About 360 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Build a closed-loop heater controller.
Parts list
- Development Boards
- Semiconductors
- Integrated Circuits
- Displays
- Sensors
- PassivesResistor 10 kΩ × 2
- Passives
- PowerUse a 24 V supply
How to build it
- Amplify the thermocouple signal
- Read it between heater pulses
- Run PID
- Set temperature with the encoder
- Add sleep and over-temperature cut-off
Common questions
What parts do I need for the soldering station controller?
Arduino Nano, MOSFET IRLZ44N, LM358 Op-Amp, SSD1306 OLED Display, Rotary encoder module (KY-040), Resistor 10 kΩ × 2, Resistor 1 kΩ and SMPS 12 V 5 A (metal case). SMPS 12 V 5 A (metal case): Use a 24 V supply.
How long does the soldering station controller take to build?
About 360 minutes for a advanced maker.
