Idea
In short
How do you build a keypad door latch model?
A 4 by 4 keypad opens a model door latch driven by a servo, as a safe learning model of an access system. You need Arduino Uno R3, 4x4 matrix keypad (membrane), SG90 Micro Servo, LED 5 mm red, LED 5 mm green, Resistor 220 Ω × 2, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 180 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Read a matrix keypad and compare a code.
Parts list
- Development Boards
- Switches
- Motors & Actuators
- Semiconductors
- Semiconductors
- PassivesResistor 220 Ω × 2
- Prototyping
- Prototyping
How to build it
- Scan the keypad rows and columns
- Store a PIN
- Compare each entry
- Move the servo latch
- Lock out after three wrong tries
Related projects
Common questions
What parts do I need for the keypad door latch model?
Arduino Uno R3, 4x4 matrix keypad (membrane), SG90 Micro Servo, LED 5 mm red, LED 5 mm green, Resistor 220 Ω × 2, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the keypad door latch model take to build?
About 180 minutes for a intermediate maker.
