Idea
In short
How do you build a PIN keypad lock box?
A keypad box opens a servo latch when the right four-digit PIN is typed and locks out for thirty seconds after three wrong tries. A teaching model, not real security. You need Arduino Nano, 4x4 matrix keypad (membrane), SG90 Micro Servo, LED 5 mm red, LED 5 mm green, Resistor 220 Ω × 2, Passive buzzer and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 150 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Build a PIN lock with a lockout.
Parts list
- Development Boards
- Switches
- Motors & Actuators
- Semiconductors
- Semiconductors
- PassivesResistor 220 Ω × 2
- Motors & Actuators
- Prototyping
How to build it
- Scan the keypad
- Collect four digits
- Compare with a stored PIN
- Open the latch for ten seconds
- Add a lockout after three wrong tries
Common questions
What parts do I need for the PIN keypad lock box?
Arduino Nano, 4x4 matrix keypad (membrane), SG90 Micro Servo, LED 5 mm red, LED 5 mm green, Resistor 220 Ω × 2, Passive buzzer and Breadboard 830 Tie Points.
How long does the PIN keypad lock box take to build?
About 150 minutes for a beginner maker.
