Projects / Ideas / Seed tray low-voltage heater

Seed tray low-voltage heater

IntermediateAgricultureIdeaReviewed
In short

How do you build a seed tray low-voltage heater?

A low-voltage heating mat under a seed tray stays at a set temperature using a thermistor and a MOSFET, powered from a 12 V adapter. You need Arduino Nano, NTC 10 kΩ waterproof probe, MOSFET IRLZ44N, Power resistor 10 Ω 5 W (cement), 12 V 2 A DC adapter, Fuse 1 A glass (5 × 20 mm), Resistor 10 kΩ and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 270 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Control a small heater safely at low voltage.

How to build it

  1. Read the probe temperature
  2. Set a target
  3. Switch the heater with a MOSFET at a slow rate
  4. Add a fuse
  5. Add an over-temperature cut-off

Related projects

Common questions

What parts do I need for the seed tray low-voltage heater?

Arduino Nano, NTC 10 kΩ waterproof probe, MOSFET IRLZ44N, Power resistor 10 Ω 5 W (cement), 12 V 2 A DC adapter, Fuse 1 A glass (5 × 20 mm), Resistor 10 kΩ and Breadboard 830 Tie Points.

How long does the seed tray low-voltage heater take to build?

About 270 minutes for a intermediate maker.